Fiat 500 Replacement Key Fob
It's possible to change the battery if your 500 remote key fob isn't working. If you do replace the battery but it is still not working the issue could be elsewhere.
At United Locksmith, we specialize in making new keys for old automobiles. We have all the tools and accessories needed to provide this service.
Dead Coin Battery
The most common reason your Fiat 500 key fob will not lock or unlock the doors is due to a dead battery. The battery of the coin cell inside the key fob is likely to drain quickly when you don't utilize it often enough. If your remote has started to show signs of a loss of range or has stopped functioning, then the battery may be dead.
Metal clips keep the battery in on the key fob. If the clips are loose, it can cause contact issues that will stop your remote from receiving power. By using a small flathead screwdriver, push the retaining clip open to take out the battery, and replace it with a brand new one. Be sure to use a replacement battery with the same kind of voltage, size and specifications as the original battery.
Water exposure can cause the key fob to corrode or be damaged. Even a small bath in soapy water can cause damage to the electronic chip inside. It is recommended to keep your key fob in a dry location.
Water Damage
Water damage could be the reason for your key fob not functioning properly. The rubber seals on key fobs keep them from getting damaged by a tiny drizzle or splash of water. However, it is crucial to keep your keys of your car away from the washing machine, ocean, and pool.
The key fob contains an electronic chip that sends an alert to the immobilizer system in your car. fiat doblo key fob replacement is what allows the 500 to lock and start. If it gets wet, however it will cease to function.
If you're looking to determine if your key fob is functioning you can clean the internal electronics with isopropyl or an electronic cleaner. It is recommended to replace a key fob in the event that it has been submerged into salt water instead of trying to fix it yourself.
While a replacement fob can cost you a bit of money, it's much less expensive than paying for your Fiat 500 to be towed to the dealer and repaired! You can also fix it yourself by following a few simple steps. Just ensure you have the correct battery type before you attempt to open your key fob. This is a job that's much easier than it looks, and there are step-by-step instructions on the internet for nearly any key fob for cars.
Faulty Chip
The chip in the key fob communicates to your vehicle's immobiliser to ensure that the vehicle is able to start when the correct key is used. If the chip is damaged or damaged the car won't start, no matter what you do.
A damaged chip could occur due to a variety of reasons, but the most common reason is water damage or the battery being dead. Whatever the reason, it is best to delegate this task to a locksmith as they will be able to replace the chip for you quickly and at an affordable price.
If your key fob will not work after being exposed to clean tap or rain water take the battery off. Clean the electronic component with paper towels. If the key fob does not work it's likely to be to be a damaged chip that will need to be replaced.
Some people will go to their dealer if they require a new Fiat fob. But, this can be expensive. United Locksmith is the best place to go if you would like to have your Fiat key fob repaired at a reasonable price. We have the equipment and know-how necessary to repair your Fiat key fob in a timely and professional manner.
Faulty Receiver Module
Fiat key fobs send an alert up 50 feet to the vehicle, which allows it to unlock and close the doors (and start the vehicle for vehicles with automatic transmissions). There are a variety of reasons why the fob could stop working. This includes a dead battery water damage, worn out buttons or a receiver issue signal interference or an issue with the chip.
If the fob was placed in the pocket of someone who has suffered severe trauma (such as being dropped onto the hard floor or washed in the washer) the fob might not be able to connect with the Body Control Module (BCM) of the vehicle. The BCM is a security device that will only accept signals from genuine keys.
You'll have to replace the fob if this occurs. A professional locksmith will take care of the entire key replacement process including programming a new one for your 500. In fact, they'll provide you with a duplicate key that works just the same way as your original fob (and costs less than the price).